Move smoothly before adding plates.
- 01
Check the available lane and start with a load that moves smoothly.
- 02
Use a stable body position and short repeatable steps. Reset if your position collapses.
- 03
Keep turns and rest consistent when comparing sessions.
Two workouts to try.
Choose one example session to practise. Use a manageable load or pace, allow room in your existing week and stop if movement becomes painful. Work and recovery are both included in the listed total.
Controlled push practice
- 5 min warm-up with light sled practice.
- 10-minute practice block: one short controlled push at the start of every 2 minutes. Walk and rest for the remainder.
- 5 min cool-down.
Five short practices with room to reset. Choose lane length and load that leave recovery time.
Build my HYROX planRun-to-push rehearsal
- 5 min warm-up.
- 3 × 5-minute blocks: 2 min easy run, one short manageable sled push, then recover until the next block.
- 5 min cool-down.
Practice the transition, not an unfamiliar maximum load.
Build my HYROX planA mistake to avoid
Treating the plates on two different sleds as equivalent race loads.
What to record
Log the sled, surface, total verified load, lane distance and stops. Write “unknown” if the empty sled mass is not known.
How to progress it
Build smoother lengths before increasing load. Change either the load or the number of lengths, rather than both at once.
Place station work alongside your runs and strength sessions. If a practice becomes demanding, account for it in the week rather than treating it as a free extra.
See a four-day training weekStandards and sources
The sessions above are Enduro Fit coaching examples. They are not official HYROX programmes. Race standards vary by format and division; the linked Singles rulebook does not replace the separate Doubles, Relay or Adaptive rules.
Official HYROX Singles rulebook · season 26/27 ↗Checked 30 October 2026. Confirm the latest rules for your event.
